SEAFLO Electronic Sensing Automatic Bilge Pump –New Design 13B SERIES 1100GPH

SEAFLO new fully automatic submersible bilge pumps with new innovative design incorporates the bilge pump and water sensor in a single housing. SEAFLO 14AB bilge pumps provide ultimate pumping performance, which helps keep your bilge clear of nuisance water, building on the genuine SEAFLO design.
The new SEAFLO 14A bilge pumps operate using an internal level sensor. When water reaches 2″ (5cm), the pump will automatically activate, removing water from the bilge. When the water level reaches 3/8″ (0.9cm) the pump will turn off until the water level rises again.
Bilges are not always clean and free from debris. If the level sensor becomes fouled by debris or contaminated water, the pump’s unique back up feature will prevent the pump from entering a run-on condition, protecting the battery while maintaining automatic operation.

- Available in three different capacities 600, 800, 1100 gallons per hour                                         - Include removable discharge straight fitting

- Removable strainer and impeller area are accessible to clear debris                                            - Stainless-steel motor shaft

- Vented impeller housing to prevent the pump from becoming airlocked                                         - Fully Submersible and ignition protected

- Threaded Discharge — easier installation, easier maintenance                                                     - Motor can be sold separately

- Pump and switch are internally wired for easy installation                                                              -High efficiency, low amp motor

- Includes check valve to prevent water back flow - Exclusive moisture tight seals

- Bilge water sensor and pump in a common housing                                                                      - Sealed efficient, long life motors

- Marine grade silicon blocked, tin coated wiring                                                                              - Quiet operation

- Compact automatic pump-no float switch needed                                                                          - CE, RoHS, ISO 8846,ISO8849 standards

- Higher Flow — 500 GPH pump with optimized impeller to provide up to 10% more flow at the same amperage

- 1-1/8” 29mm 90o fitting sold separately with 360° rotation function to meet any angle requirement.

- A 3rd wire allows for manual over-ride using SEAFLO switch panel or it can activate an alarm or indicator lamp.

- Modular design easy to disassemble, clean snap lock strainer and replace accessories

- Check for water every 2.5 minutes, Runs for a half second Consumes 0.25 amps per day

- Auto Sense Intelligence — integral water level sensor controls the pump automatically

- New innovative split quick-connect joint design removes and installs in seconds! No need to disconnect base or plumbing when replacing pump, which can meet    the needs of most users